Nematron ePC-Lite Series with N2800 CPU Uživatelský manuál stáhnout pdf (Strana 16)

Protective Cover Installation

(Optional if desired)

Step 1: Gather the parts of the protective cover; top shell,

bottom shell, label insert, and wire tie. The

picture shows wire tie (top), label insert (right),

bottom shell (left), and top shell (lower right).

Step 2: Insert your pre-wired connector (with the screws

facing up) into the bottom shell. (See manual

for cable wiring instructions).

Step 3: Insert the wire tie from the bottom shell, loop around

the cable and come back out of the opposite

hole in the bottom shell.

Step 4: Tighten the wire tie around the cable and the

bottom shell.

Step 5: Seat the top shell onto the bottom as shown. Insert

label strip (if desired) in slot on top shell and

bottom shell.

Step 6: Snap the top and bottom shells together.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21

Žádné komentáře

Nematron ePC-Lite Series with N2800 CPU Uživatelský manuál Strana 16