Nematron Pointe Controller Uživatelský manuál stáhnout pdf (Strana 243)

100

101

Pointe Controller User Guide Appendix A: OptiLogic Technical Specifications

241

Each Output point, from 0 through 7, is associated with a single Output Bit tag

(%QX).

To configure an Output, click the

to the right and select an Output Bit tag

from the pop-up menu. Each tag can be used only once.

NOTE: You can leave any or all Outputs unconfigured, but if you do, those I/O

points will not be available to your project.

Failsafe tab

If, during runtime, your project fails to respond for a given timeout interval, then

the Pointe Controller unit will automatically set all Output points to

preconfigured failsafes. Parameters for this tab include:

 Timeout Interval (ms) – Wait time in milliseconds after project failure

before Outputs switch to configured Output Actions.

NOTE: This value of Timeout Interval is taken from the project’s

preferences and is not editable in this window. To edit this value, see Edit

Preferences.

 Output n Action – Each Output has three possible failsafe actions:

o Fail ON – On Fail condition, turn this Output OFF.

o Fail OFF – On Fail condition, turn this Output ON.

o Last Value (default) – On Fail condition, leave this Output in its

current state.

To configure an Output Action, click the

to the right and select an

action from the pop-up menu.

1 2 ... 238 239 240 241 242 243 244 245 246 247 248 ... 440 441

Komentáře k této Příručce

Žádné komentáře

Nematron Pointe Controller Uživatelský manuál Strana 243

Komentáře k této Příručce