Nematron Pointe Controller Uživatelský manuál stáhnout pdf (Strana 305)

100

101

Pointe Controller User Guide Appendix B: Flow Chart Command Reference

303

B.2 Timer Commands

Timer commands (in a Process block) are used to start, stop, and reset Timers. (For

more information on defining Timers in Logic memory, see page 117.)

B.2.1 Timer Start and Timer Stop

These commands can be selected from the Timer commands list.

When used in a Flow Chart, the Timer Start and Timer Stop commands start and

stop a specified Timer.

Parameters for these commands include:

 Timer – The Timer to be started or stopped by the command.

To configure the Timer parameter, click the

button to open a standard

Build Timer ID dialog.

NOTE: If the Timer was previously stopped, the Timer Start command resumes the

Timer from its last value. To start the Timer from 0, it must first be reset using the

Timer Reset command.

B.2.2 Timer Reset

This command can be selected from the Timer commands list.

1 2 ... 300 301 302 303 304 305 306 307 308 309 310 ... 440 441

Komentáře k této Příručce

Žádné komentáře

Nematron Pointe Controller Uživatelský manuál Strana 305

Komentáře k této Příručce